Supra generations

    Kaufe und verkaufe gebrauchte oder neue Teile kostenlos auf SUPRA.PARTS

    Supra generations

    The Toyota Supra Community for all Supra generations

    Toyota Supra A90

    Owners of the fifth generation Toyota Supra are thrilled about that car

    Toyota Supra MKIV

    In July 1993, the fourth and so far last generation of the Supra came on the market. Internationally, this type is called " Supra MKIV ".

    Toyota Supra MKIII

    In early 1986, the third generation of the Supra was introduced. It is also the first that has not been marketed with the suffix Celica.

    Celica Supra (MK2)

    The second generation was presented in the fall of 1981 and had a completely independent drive with the new (170 hp) 6-cylinder engines.

    2000GT & Supra MK1

    The first Supra built from spring 1978 to summer 1981 was still offered as a top version of the Celica first in Japan and later in the United States.

    Ladedruck erhöhen!!! | Forum

    Suprapepe Owner
    An alle Suprafahrer die den Ladedruck erhöht haben!!!!
    Ich möchte wissen ob Ihr euren Ladedruck je nach Bedarf erhöht oder runter stellt?????
    Ich möchte meinen Ladedruck auf 1,2 bar erhöhen!
    Kann ich ihn immer so fahren oder sollte ich lieber mit weniger Bar fahren???
    Kann mir nicht vorstellen vor jeder Fahrt hoch oder runter zu stellen!!
    Muß ich auf die Laufleistung oder Alter der Supra achten???
    Meine Supra ca 80000 km und 1994 Baujahr.
    Ich Hoffe das Ihr mir eure Erfahrungen schreibt!!!
    Gruß aus Hamburg
    Robert
    SpeedUp Owner
    80000 Km ist noch neuwertig :grinning: Mit dieser Laufleistung solltest Du absolut keine Probleme haben.

    Die 1,2 Bar sind im Normalfall "Peak". D.h. der Ladedruck wird nur kurze Zeit auf 1,2 Bar sein und dann wieder abfallen, insofern kannst Du ihn permanent auf 1,2 Bar belassen.
    Zudem fährst Du ja wahrscheinlich auch nicht immer Vollgas.

    Mit einem elektr. Boostcontroller kannst Du sehr leicht den Ladedruck regeln.
    Meistens genügt ein Knopfdruck um zwischen zwei Settings umzustellen, aber wie schon gesagt, bei 1,2 Bar muss das nicht sein.

    AustrianSupra Owner
    wie schon gesagt..........lass die 1,2 bar eingestellt.

    Oxwall Community Software